Guidelines for using tile leveler

The use of tile levelers requires following certain steps and precautions to ensure the flatness and aesthetics of tile laying. The following is a guide to using a Tile Leveler based on search results:

preparation

Before using a tile leveler, the following preparations need to be made:

Cleaning the floor: Ensure that the floor is clean and Smooth, free of debris and dust.

Preparation materials: Prepare leveling agent and cement.

Mixing leveling agent: Mix the leveling agent to the appropriate concentration according to the instructions.

Ground treatment: Pour leveling agent onto the ground and evenly distribute it with a scraper.

Drying leveling agent: Wait for the leveling agent to dry or reach the indicated drying time.

Ceramic tile pre laying: Before formal laying, pre lay and check the position and gaps of the tiles for suitability.

Usage steps

The steps for using a tile leveler are as follows 17:

Ceramic tile gap treatment: When laying ceramic tiles, leave a gap of about 2mm.

Insert the leveler: Insert the leveler into the tile gap and compact it.

Fixed leveler: Rotate the leveler 90 degrees to secure it at the bottom.

Adjust level: Use a wrench to adjust the leveling device and cover to keep adjacent tiles level.

Wait for drying: After the paving is completed, wait for at least 5 hours for the cement to fully dry and solidify.

matters needing attention

When using a tile leveler, the following points should be noted 246:

Ceramic tile surface requirements: Ensure that the ceramic tile surface is clean, free of dust, scratches, color differences, cracks, pollution, etc.

Gap control: The width of the gap at the junction of the floor tiles and the wall should be within the width range of the skirting line to facilitate coverage.

Flatness inspection: Use a 2M level to check the flatness of the floor tiles, with an error not exceeding 3mm and a height difference between adjacent tiles not exceeding 2mm.

Adhesive firmness: Ensure that the tiles are firmly adhered, with a hollow area not exceeding 5% of the total and a single hollow area not exceeding 10%.

Gap width: The tile gap width should be controlled within 2mm, and the pointing should be uniform and straight.

Horizontal error: The horizontal error shall not exceed 4mm.

Remove the leveling device.

After the use of the tile leveler is completed, the method of removing the leveler is as follows:

Dismantling the base: The base of the leveling device is disposable, just knock off the bottom, remove the plug and push clamp.